Blast room to decontamination of parts

Design, Manufacture and installation of blast room to decontamination of parts inside of The Workshop and Decontamination Building of a Nuclear Power Plant.. Is a facility prepared to clean up and decontaminate of parts in a secure and hermetic, by means of very high pressure water projection..

The walls and roof were covered, inside and exterior side, with sheet made of stainless steel, providing a properly protection against corrosion. The walls were supplied with plates made of plumb, in a sandwich configuration, to guarantee the best protection from radiology point of view.

Technical data
Useful volume 80 m³
Power 110 KW
Pressure 500-2600 Bar
Temperature 40° C
Water flow 17 l/min
Air renovations 55 r/h